Walk Ride Rodeosd Apr 2026

toward the center. This creates four "flaps" that will be the legs.

Fold the middle section at the other end down or curl it with a pencil to make a .

: Lightly draw two lines along the length to divide the rectangle into three equal columns ( Walk Ride RodeoSD

each). These will be the (outer columns) and the body (middle column). Cut the Legs : On both ends, cut along those lines about

: A long book or a piece of cardboard to use as a ramp. Step-by-Step Instructions toward the center

: Place your horse at the top of a slanted surface (like a book propped up by a few other books). Give it a gentle tap or tilt to start the rocking motion. It should "walk" down the hill by shifting its weight from one curved foot to the other. Troubleshooting

: This is the most critical step. Cut the bottom of each leg into a smooth curve . The inner edge of each foot should be slightly shorter than the outer edge to help it rock side-to-side. Fold the Head and Tail : Fold the middle section at one end up to make a head . : Lightly draw two lines along the length

: If it tips, make the legs wider or the body shorter to lower its center of gravity. Walking Horses Made of Paper - J Bell