Nad Phono Preamp Pp2 Manual -

The is a compact, low-noise device designed to add a turntable to modern amplifiers or receivers that only have "Line-Level" inputs (like CD, AUX, or Tuner). It supports both Moving Magnet (MM) and Moving Coil (MC) cartridges via separate inputs and a rear selector switch. 1. Setup & Installation

: Ensure all equipment is turned off and the PP 2 is disconnected from its power supply. Connect Turntable :

Ensure the turntable's ground wire is securely attached to the PP 2 . Nad Phono Preamp Pp2 Manual

: Use RCA cables to connect the PP 2 Output to a Line-Level input (e.g., CD, AUX, Tuner) on your receiver.

If you encounter issues, refer to the following common solutions: : The is a compact, low-noise device designed to

Follow these steps to correctly integrate the PP 2 into your audio system:

Plug your turntable's RCA leads into the or MM inputs on the back of the PP 2, depending on your cartridge type. Match the colors: Red for Right (R) and White for Left (L). Setup & Installation : Ensure all equipment is

: Check that all RCA plugs are fully inserted into their respective sockets on both the PP 2 and the amplifier.