N_031.mp4 Apr 2026

: Measure the signal between Pin 2 (signal) and Pin 1 (ground). Use a voltmeter at test point MP4 on the main board. 2. Angle Sensor Adjustment

: Reconnect hoses and bleed the air from the hydraulic lines to ensure accurate readings. ⚠️ Critical Safety Checks n_031.mp4

The length sensor measures boom extension via a potentiometer in the cable reel. : Measure the signal between Pin 2 (signal)

: Connect a voltmeter to the main board (Black to MP15 , Red to MP4/MP5 ). Adjust potentiometers P4 or P5 to reach exactly 0.500V (500mV) . Angle Sensor Adjustment : Reconnect hoses and bleed

: Check the angle display at 20°, 45°, and 70°. The display must be within ±0.5 degrees of the inclinometer reading.

Detailed wiring diagrams and flowcharts can be found in the PAT DS350 Service Manual or via WIKA Mobile Control Support . LENGTH-ANGLE-RADIUS-LOAD INDICATING SYSTEM

This guide covers the assembly and adjustment of core components found in the system's technical manuals. 1. Cable Reel & Length Sensor