Hoffman Finish Balancer Manual ◉ 【FREE】

Before operating the machine, ensure the following safety standards are met:

: Ensure the machine is placed on a flat, non-resilient floor. Keep unauthorized personnel away from the balancer during the spin cycle. Hoffman Finish Balancer Manual

: The machine must touch the floor at its three specific support points for stability. Before operating the machine, ensure the following safety

: Verify that the mains voltage (typically 115V or 230V) matches the rating plate on the balancer. : Verify that the mains voltage (typically 115V

: Ensure the machine shaft, driving pulley, and wheel flanges are clean of dirt, oil, or grease, as any debris can affect balancing accuracy. 3. Operating Instructions (On-Car Balancing)

Use the low speed (marked "I") for most vehicles, which typically reaches approximately .

: Remove the pulley from the tire (about 5–7 cm) and wait for the display to show the unbalance value and angular position.