The following steps are standard for calibrating the CDM9 drive using the internal :
Switch SW1 to OFF . The door is now calibrated to its vertical limits. 4. Troubleshooting and Diagnostics CDM9з”µжњєзљ„зј–зЁ‹пј€VLпј‰.mov
Press the bottom gasket until the yellow LEDs go out. The following steps are standard for calibrating the
Manually move the door to a height of approximately 100 cm above the floor. CDM9з”µжњєзљ„зј–зЁ‹пј€VLпј‰.mov
Before initiating the "programming the road" sequence, ensure:
Check the limit switches and sliding clutch for proper adjustment.