: Check if a stray thread is caught in the teeth.
: Slide the left side of the tape into the wider, rounded end (the "mouth") of the slider. BFVanilla.zip
: Sew a "bar tack" (a wide zigzag stitch in place) across the teeth at the bottom end. : Check if a stray thread is caught in the teeth
: If your project is longer than your available tape, do not sew two tapes end-to-end; it is better to buy a single continuous zipper roll to maintain structural integrity. 💡 Troubleshooting Common Issues : If your project is longer than your
: The slider might be too loose. Use a pair of pliers to very gently squeeze the sides of the slider together.
: Pull the slider down the entire length to ensure there are no gaps or "bubbles" in the coil. 🛡️ Finishing the "Long Piece"